Strong light transmittance. Crystal-like transparency, this light transmittance can be compared with glass, lighter than glass.

1、 strong impact resistance, not as fragile as glass, even if damaged does not form sharp fragments.

2、 the material has excellent weather resistance, high surface hardness and surface luster, good high temperature resistance, wear resistance and aluminum close. Even if it is exposed to sunlight for a long time, wind and rain will not change its performance. It has good anti-aging performance and can be used safely outdoors.

3、strong comprehensive performance, good molding performance, good dyeing effect. Provide designers with a variety of choices.

4、environmental protection and non-toxic. Even with long-term contact with people is harmless, high flame retardant performance, even if burning will not produce toxic gas.

5、good stability, corrosion resistance to a variety of chemicals.

Used in Windows, soundproof doors and Windows, lighting covers, telephone booths, light boxes, signboards, signs, display racks, cars and other vehicle doors and Windows, baby incubators, various surgical instruments, bathroom facilities, handicrafts, cosmetics, supports, aquariums and so on.

Q: What are the key considerations for installing PC sheets?
A: Proper installation is critical to prevent damage and leakage.

Correct Side Out: The side with the UV-protective coating must face the sun. The protective film is usually printed with this information (e.g., "UV side" or "This side out").

Thermal Expansion/Contraction: PC expands and contracts significantly with temperature changes. You must:

Use oversized drill holes.

Use specialty EPDM or neoprene washer-headed screws.

Never over-tighten screws.

Sealants: Use only neutral cure silicone sealants (e.g., Dow Corning 795). NEVER use acrylic, ammonia-based, or solvent-based sealants as they cause chemical stress cracking and will destroy the sheet.

Bending: Sheets can be cold-curved only along the direction of the flutes (for multi-wall) or lengthwise. Do not bend across the flutes. The minimum bending radius is typically 150-200 times the sheet thickness.