PC endurance plate of these installation methods guess you do not know, Zhuoni to give you a detailed explanation. Polycarbonate is a thermosetting plastic in which polycarbonate plates are commonly used, and generally our customers are turned into endurance plates, pc endurance plates or locking plates. It is extremely strong, resistant to ultraviolet light, and presents a beautiful and generous appearance. It has full transparent and incomplete transparent styles, and is ideal for selection at the level of engineering building plates. The following installation methods are for your reference:

First, the polycarbonate plate should be bent in the direction of the effort, do not bend horizontally. The bending radius should be the thickness of the plate: 175 times the hollow two-layer board, 185 times the three-layer board, and 200 times the four-layer board. The bending radius of the solid pc endurance plate is the same as the thickness of 175 times below. The bending part of the plate is strictly prohibited from fixing with screws.

Second, when installing the plastic hollow plate and solid core pc endurance plate, at the interface between the plate and the plate, be sure to bury the thermal deformation gap according to the plate specifications, the linear expansion coefficient is 0.065 mm /m ° C, and it is strictly prohibited to tap screws, pull the core rivets, and so on immediately across the plate fixed. If it must be crossed, be sure to drill holes in the plate diameter more than 100% of the diameter of the tapping screw or core rivet, and then reduce the tapping screw or bolt according to the center point of the expansion hole to ensure that the plate can be freely telescoped in any direction.

Third, the steel frame structure frame must be installed firmly, maintain stability, and prevent damage to the polycarbonate plate due to the frame.

Fourth, the raw materials of the steel frame structure must be consistent with the total area of the structure, which is convenient for engineering construction.

Fifth, the aluminum alloy profile decoration bar is consistent with the thickness and total area of the selected plate, which can better maintain the plate and increase the use period.

6. The sealant in contact with the polycarbonate plate must use neutral silicon copper adhesive, and it is strictly prohibited to use a partial alkali, acid alkaline, and unknown sealant with organic solvents. Avoid direct contact between polycarbonate plate and organic chemical organic solvents, aqueous solutions, and volatile vapors. If paint with diluent diluent is used to paint the polycarbonate plate fixing bracket, make sure that the paint has dried thoroughly before installing the polycarbonate plate. Do not use paint with diluent diluent to brush the steel frame with polycarbonate plate installed.

Seven, the installation of polycarbonate plate fixed as far as possible to choose the enterprise's special leakage repair equipment around the scaffold fastenings or the company's special tablet computer decoration strip, if the use of other enterprises of the tablet computer sealing strip must ensure that the sealing strip material is EPDM vulcanized rubber or butadized rubber, It is strictly prohibited to use polyethylene (PVC), natural rubber and other chemical substances that are harmful to polycarbonate board.

8. When installing the polycarbonate plate, it is necessary to face the protective film containing the text of the plate with UV co-extrusion to block the ultraviolet layer outdoors, do not reverse, and remove the protective film immediately after installation to prevent the adhesion of the protective film and polycarbonate plate after sunlight exposure.

9. Before the installation of the polycarbonate plate, the protective film about 30mm from the edge should be loosened. It is strictly prohibited to press the protective film under the aluminum profile and then cut the protective film with a knife. All parts of the polycarbonate plate should not be scratched.

Ten, the polycarbonate plate cut cross-section with aluminum foil tape or moisture-proof and breathable tape to prevent water vapor dust and small bugs into the air, harm the clarity of the polycarbonate plate and meiguandafangdu.