The wet test assembly method of endurance plate engineering projects is key for small and medium-sized equipment, such as garages, subway station canopies, rain eaves, greenhouses and many other places that replace laminated glass. The wet test assembly method is selected, and the basic requirement is that the sealing system software should be able to bear a certain amount of movement of the plate, and the endurance plate can allow thermal deformation without reducing its adhesion with the structure and the middle of the plate.

1, light: the proportion is only half of the general laminated glass, and it is not easy to destroy, and the transportation and installation save costs, especially in the suitable high and large house construction applications;

2, anti-condensation water: under normal conditions, when the outdoor temperature is 0 ° C, room temperature is 23 ° C, as long as the ambient humidity in the room is less than 80%, the surface of the raw material is not easy to condensate water;

3, thermal conductivity: high front endurance plate has less than the general glass and other plastic thermal conductivity (K value), so that the heat damage is greatly reduced, for heating machinery and equipment engineering construction, is a new type of environmental protection materials;

4, impact resistance: PC is the best kind of impact resistance in thermoplastics, and the endurance plate made of PC can maintain stable impact resistance characteristics in a very wide temperature range for a long time, and has the reputation of "no glass slag" and "ring steel";

5, acid resistance: high edge endurance plate at indoor temperature can resist a variety of organic matter, strong oxidant, edible oil, neutral solution, aliphatic hydrocarbon and its ethanol corrosion. Endurance plate dissolves chloroethane, slightly dissolves aliphatic hydrocarbons and ketones, can be destroyed by alkali, and will be soluble in banana water and ethanol;

6, flame retardant, fire safety PC board has excellent fire safety, by China's fire safety building decoration materials supervision and management center testing, according to GB8624-1997 specifications, flame retardant B1 level. The ignition point of the plate itself is 630 ° C, and the whole process of igniting is not easy to cause harmful gases, and it is not easy to promote the spread of long fire, and it self-extinguishing after dark fire.

7, cold bending installation, high temperature resistance, low temperature resistance.Endurance plate engineering project dry test assembly method, refers to the use of no sealant. Because it is sometimes possible to produce a situation where the sheet expansion exceeds the widening limit of the sealant and in order to better the artistic aesthetic level, the advantage of the dry test assembly system software is that the window seal is clamped inside the decorative strip, so that the sheet can be moved freely when the swelling and load position are moved. This type of installation method cannot use PVC window seals, because the tackifier added to the soft plastic PVC is transferred to the surface of the plate, which will crack the surface of the plate, and even the entire PCB board is destroyed.