How about an ESD pc board

Anti-static PC board endurance board is built of polycarbonate as raw materials, after a unique processing process to produce a strong light transmission of thermosetting raw materials. And the selection of advanced coating technology on the surface of the PC endurance plate, this type of coating is the anti-static electric hard film layer. The original physical characteristics of the base steel plate are completely preserved, and it also has some antistatic actual effects that the general PC board does not have. Under normal conditions, if the resistor on the surface of the PC endurance plate is 6 to 8 times that of the general, it is a good anti-static performance, which can reasonably avoid the accumulation of dust, prevent the damage that is likely to be caused by electrostatic induction, and then consider the unique requirements of industrial production in the new technology period.

The experimental results show that the antistatic performance of pc endurance plate can be ensured very well under -40 ~ -130℃ and wet and cold standards, and the dielectric loss Angle tangent value and relative dielectric constant transition parameters between 10 ~ 130℃. The actual effect of the anti-static PC endurance plate is the key to the resistance size of the volume and the working voltage compressive strength of the penetration is not too strong, compared with pvc film, these two raw materials are similar, and are suitable for the general production and manufacturing of electrical components, and its common power capacitors and electrical equipment.

pc board processing production process is not complicated, so many companies can emulate manufacturing, but few companies can carry out product research and development of production process. With the increasing provision of goods in the field, green manufacturing, green environmental protection, green economy, high performance and other processing processes or commodities will become a new breakthrough point in the development of the industry, building coating enterprises can only independently transform and develop into quantitative product research and development enterprises, in order to gain a firm foothold. Enterprise market competition is increasingly fierce, many enterprises are working hard to develop new technology enterprises, only the real grasp of technology research and development methods, can produce new competitiveness in the future

 fully prepared. The key is to use outdoors, because of air pollution, the cleaning of the sunshine board is super critical. Warm water, neutral soap, soft textiles or sponges should be used to clean up, not strong acids, isoprotection, macrolides, halogens, butyl chemical fibers, brushes, hard cloth to scrub the surface of the sunshine board. Outdoor sunlight board is generally used on the roof and other multi-storey buildings, which gives the sunlight board a lot of difficulties in cleaning. Therefore, the PC board special cleaning agent that is suitable for high pressure water pump and can be cleaned by flushing will be warmly welcomed by customers. pc board processing to high efficiency, environmental protection, green, low-carbon environmental protection as the key orientation transformation development has been urgent. Enterprises must contribute to the development of structural 

transformation and step into a high-level level.